10-349-007M
D PULL STATION DETAIL
(�
SWII H fRA, LL.E® I
j�
k
L
2 ABORT DETAIL
Z
f VC L
DETECTOR DETAIL
•am& H.T.L
5 BELL DETAIL
6 HORN/STROBE DETAIL
-9 NOT USED
f 00" KIM
ELECTRICAL ACTUATOR TECHNICAL INFORMATION
POWER REQUIREMENT: 24V DC
RESISTANCE AT 20 DEG C: 25 OHMS POWER
CONSUMPTION: 24 WATTS STROKE: 3MM
TEMPERATURE CLASS: CLASS F (155 DEG C)
ELECTRICAL CONNECTION: 3 PIN PLUG CONNECTOR
TO DIN 43650 & ISO 4400 CABLE GLAND PG9
NOTE:
CONNECTED +VE TO TERMINAL 1 AND —VE TO
TERMINAL 2 ON PLUG CONNECTOR END OF LINE
MONITORING RESISTOR TO BE FITTED ON SITE.
8 M ELECTRIC ACTUATOR DETAIL
)_ soma WTA
-T
3
CONTROL
PANEL
RISER DIAGRAM INSTALLATION NOTES
DTK-120HW
Warning: DITEK recommends a licensed electrician Install the DTK-120HW.
DITEK units should be connected to the load side of the fuse or circuit breaker.
Caution: Measure all voltages to verffy the applied voltage does not exceed the voltage
rating of the unlL
1. Before beginning Installation, turn off main breaker.
2. Remove panel cover.
3. Mount this unit through an appropriately sized knockout on the side of the panel,
securing It with the retaining nu•
4. Note: Connect the green wire to mechanical ground first.
5. White vAre to neutral second.
6. Black vAre to phase last.
7. Replace panel cover.
8. After all connections have been made, and no hazards exist, restore power.
9. For further Information or technical support please call 1-888-472-6100.
Expected System voltage: WK
120 HW
L1 -N 120V
Ll -G 120V BLX ORN
N-G 0 V
3X 5"
CONDUIT 2X SLOT •5' X.1Ir
dal
N943LE
��g 1-6
10 SURGE PROTECTOR DETAIL
NOT USED SCAM MM
M) Neutral
118rL04112AWO
LEADS
i
3"
4
"I.
9 12 NOT USED same ILTA
NOT
NOT USED
13 •m& KTaN
NOT USED
14 . some OLT&
NOT USED
•am& ILTA
Tj
II
Vro:s
Ak
N
N
co
cr) co
Ci Cf Cq )
cr LO
:w Lo
cr)
CO
q
(a C�
,
U M
_j
16u-
A
<
M
Coto UjZ
UJI N
w
GO 0
XLL
IL
LULJJ
<
pz��
00
cm a
-Ij
3
Tj
II
Vro:s
Ak