14-1164-010Plumbing Floor Plan
Scale: 3/8" : V -0"
5GOi=E OF WOR<:
- REPLACE ALL PLUMBING= FIXTURES
-NEW WATER SUf= ='LY LINES
-NEW INSTANT WATER HEATER
-ALL EX15TING SANITARY LINES ARE EXI5TING TO REMAIN
PLUMBING SYMBOL LEGEND
SYMBOL
DESCRIPTION
B. DRAWINGS: Refer to all drawings for coordination of the
EXISTING SANITARY LINE
plumbing work.
SANITARY LINE
— — — — —
VENT LINE
GW
GREASE WASTE LINE
—�-- —�-
SAFEWASTE LINE
CD
CONDENSATE LINE
—
COLD WATER LINE
--
HOT WATER LINE
labor.
GATE VALVE
FCO
FLUSH CLEAN OUT
per foot minimum for 3" and larger and at 1/4" slope
FLOOR PENETRATION
for 2 1/2" pipes and smaller.
MECHANICAL SHOCK ARRESTOR
F. ALL materials shall be new, free of defects and correctly
7. VALVES: Domestic water valves shall be of bronze body,
WCO
WALL CLEANOUT
VTR
VENT THRU ROOF
COOG
CLEANOUT ON GRADE
HB
HOSE BIBB
heaters, and plumbing fixtures. No work shall proceed without
SHUT OFF VALVE ON RISER
the approval of these submittals.
FLOOR DRAIN W/
3. PLUMBING FIXTURES: Fixtures shall be as selected by owner
TRAP RESEAL
GENERAL PLUMBING NOTES:
1. A. ALL WORK SHALL BE DONE in accordance with the Florida
Building Code and with all applicable regulations.
F. Condensate drain: DWV Copper pipe & fittings.
B. DRAWINGS: Refer to all drawings for coordination of the
G. Domestic water supply assembly. Chrome finish tubing
with angle off valves.
plumbing work.
VENT
C. ARRANGE AND PAY for all permits, licenses, inspections
5. ALL AUTOMATIC ELECTRIC water heaters shall meet the
and tests. Obtain the required certificates and present
standards of the latest energy efficiency code.
to owner.
6. PIPING TEST AND DISINFECTIONS:
D. GUARANTEE: The completed installation shall be fully
A. Test: All sanitary and domestic water supply piping shall
guaranteed against defective materials and /or improper
be tested for leaks before piping is concealed or connected
workmanship for a minimum of one year for material and
to equipment and plumbing fixtures.
labor.
B. Disinfection: All domestic water piping shall be
E. ALL HORIZONTAL SANITARY PIPING shall slope at 1/8 inch
disinfected by introducing a solution of calcium
per foot minimum for 3" and larger and at 1/4" slope
hypochlorite of 50 parts per million of chloride and as
for 2 1/2" pipes and smaller.
per AWWA Standards.
F. ALL materials shall be new, free of defects and correctly
7. VALVES: Domestic water valves shall be of bronze body,
labeled with their appropriate listing agency.
sweat ends.
2. SHOP DRAWINGS: Contractor shall submit for approval, within
8. HOSE BIBBS: Shall be 3/4 inch. rough brass construction with
30 days of signing contract, a minimum of five copies of fully
shut off valve and vacuum breaker.
descriptive literature, including but not limited to: water
1/2"
heaters, and plumbing fixtures. No work shall proceed without
9. ALL OUTDOORS FLOOR clean outs shall be terminated up to grade
the approval of these submittals.
and shall be marked.
3. PLUMBING FIXTURES: Fixtures shall be as selected by owner
10. CONTRACTOR SHALL COORDINATE exact location of all plumbing
system piping before starting any work. Notify
and shall be furnished and installed by this contractor. Fixtures
shall be complete with drains, traps, supplies and any other
Architect /Engineer of any deviations from design drawings.
accessory required. Fixtures and faucets shall comply with the
11. CONTRACTOR SHALL provide all necessary labor and materials
FBC Water saving standards.
for a complete "turn -key" plumbing system.
4. MATERIALS: PIPING
12. CONTRACTOR SHALL keep accurate as -built dwgs on the field and
A Drainage and Vent piping (Below Grade): shall be hub and spigot service weight
provide them to owner once job is complete.
cast iron with gasketed push -on joints. Polyvinyl Chloride (PVC) plastic pipe ((TYPE
13. CONTRACTOR SHALL familiarize himself with job site and with all
DWV) ASTM D 2665, ASTM D 2949, CSA B181.2) is acceptable.
construction documents including architectural, electrical. HVAC, and
B. Drainage and vEnt piping (Above Grade): shall be hubless service weight cast iron
structural dwgs, prior to bidding. Adjustments in the plumbing system to
with neoprene gaskets and stainless steel band joints. Polyvinyl Chloride (PVC)
accomodate other disciplines should be expected, and shall not represent
plastic pipe ((TYPE DWV) ASTM D 2665, ASTM D 2949, ASTM F 1488, CSA B181.2)
additional costs to owner. Notify Architect /Enigneer of any discrepancies
is acceptable.
prior to commencement of work.
C. Water piping (Below Grade): shall be copper type "K" ASTM B -88 with wrought
14. Provide wall cleanouts at the base of every stack.
copper fittings and 95 -5 soldered joints. Paint with bitumastic when installed in
15. CONTRACTOR SHALL obtain insuranceto protet against public liability
grade,
and property damage for the duration of work.
Water piping (Above Grade): shall be copper type "L" ASTM B -88 with wrought
16. CONTRACTOR SHALL use dimensions in architectural drawings to
copper fittings and 95 -5 soldered joints. CPVC (Chlorinated Polyvinyl Chloride) ASTM
rough -in plumbing work.
D 2846 pipe and tubing with CPVC plastic fittings ASTM F 437 is acceptable.
D. All piping in return plenum shall not be PVC or CPVC, only metallic
material will be use within the plenum Area
E. Insulated all hot water and condensate drain piping.
LOH
LUIS O. DE LA HOz
PE# 73932 ._,.
BB57 NW 17BTH ST
MIAMI, FL 33018
PHONE: (305) 903 -BB 16
LODELAHOZ @YAHOO.Es -
•
,ft t� ••• N •;
i
�O; 2 :CL:
�: �� • u.!
Vii• � '• ....•� �Q,' �s`
S1O��.
•#$less
Luis 0. de la Hoz, PE
Lie# 73932
W
PLUMBING FIXTURE CONNECTION SCHEDULE
NO.
DESCRIPTION
WASTE
VENT
WATER
REMARKS
COLD
HOT
WG
WATER CLOSET
3"
2"
1/2"
FLUSH VALVE TYPE TANK, 1.28 GPF,
FLOOR MOUNTED.
LAV
LAVATORY
1 1/2"
1 1/2"
1/2"
AS SELECTED BY OWNER.
PROVIDE 1.0 GPM FAUCET
yyM
CLOTHES WASHER
3"
2"
1/2"
1/2"
RECESSED BOX GUY GREYPT200 OR EQUAL
SH
SHOWER [1]
2"
2"
1/2"
1/2"
PROVIDE 1.5 PM SHOWERHEAD
LSK
LAUNDRY SINK
2"
2"
1/2"
1/2"
AS SELECTED BY OWNER.
PROVIDE 1.0 GPM FAUCET
KSK
KITCHEN SINK
2"
2"
1/2"
1/2"
AS SELECTED BY OWNER.
PROVIDE 1.0 GPM FAUCET
[1] PROVIDE ANTI —SCALD VALVE.
NOTES:
1.— All exposed trim, such as P— traps, angle stops, and supplies shall be chrome plated.
2.— All fixtures shall comply with Reference Standards as per FBC 2007 Plumbing 406 through 421.
3.— All Plumbing Fixtures to be specified by Architect. Please see Architectural Drawing for further information.
LOH
LUIS O. DE LA HOz
PE# 73932 ._,.
BB57 NW 17BTH ST
MIAMI, FL 33018
PHONE: (305) 903 -BB 16
LODELAHOZ @YAHOO.Es -
•
,ft t� ••• N •;
i
�O; 2 :CL:
�: �� • u.!
Vii• � '• ....•� �Q,' �s`
S1O��.
•#$less
Luis 0. de la Hoz, PE
Lie# 73932
W