05-192-002DAB Door mnanygluc. ACCECrANCE No.: 00- 1121.01
.APIPRom: FEB 2:2 2001
;Exin 6
MOnCE OF ACCEPTANCE: SPECMC CONDITIONS
1. SCOPE
This approves a sectional steel garage door 16' -2" wide x 6' -ti" through 16 °4" high, as described in Section.
2 of this Notice of Acceptance (NOA), designed to comply with the South Florida Building Code, 1994
Edition for MiaTni Dade County. For the locations where the pressure requirem", as determined by SFBC
Chapter 23, do not exceed the Design Pressure Rating values indicated in the approved drawings.
2. PRODUCT DESCRIPTION
The DAR Sectional GaraZe Door Model 324 and its components shall be constructed in strict compliance
with the following documents: Drawing No, 00 -18, titled "Sectional Residential Garage Door" prepared by
Al- Parooq Corporation, drawn on 08/24/00, with last revision on 01/29/01, sheet I through 3 of 3. They bear
the Miami-Dade County Product Control Approval stamp with the Notice of Acceptance number and
approval date by the Ifiani Dade County Product Control Division. These documents shall heminai%r bo
referred to as the approved drawings.
3. LIlV;[ITATIONS
This approval requires the manuilacturer to do testing of all coils used to fabricate door panels under this
Notice of Acceptance, A minimum of 2 specimens shall be cut from each coil and tensile tested according to
ASTM &E by a Dade County approved laboratory ,selected and paid by the manufacturer. Every 3 months,
four times a year, the manufacturer shall mail to this office: a copy of the tested reports with confirmation
that the specimens were selected from coils at the manufacturer production facilities: And a. notarized
statement from the manufacturer that only coils with yield strength of 34,000 psi or more shall be used to
make door panels for Dade County under this Notice of Acceptance.
4. INSTALLATION
4.1 The sectional steel garage door and its components shall be installed in strict compliance with the
approved drawings.
4.2 The installation of this door does no# require a hurricane protection system.
43 Units with dimensions equal • to or smaller than those shown in the approved drawing shall qualify
under this approval.
S. LABELING
Each door shall bear a permanent label with the manufacturer's name or logo, city, state and following
statement: "Miami Dade County Product Control Approved".
6. BURMING PF3u1'iir REQUIREMENTS
6.1 Application for building permit shall be accompanied by copies of the following:
6.1_1 This Notice of Acceptance.
6.1.2 Duplicate copies of the approved drawings as identified in Section 2 of this NOA, clearly
malted to show the components selected for the proposed installation.
6.13 Any other documents required by the Building Official or the South Florida Ruilding Code
(SFBC) in order to properly evaluate the instailation of this *V m.
Caudido Font, PE. Sr. Product Control Examiner
Product Control Division
2